Installing a Brick Paver Walkway or Red Clay Bricks

The use of Bricks or Pavers to develop a sidewalk or patio area matches a house in a method that is unmatched. In addition, setting up a Brick or Paver pathway does not always need a pro.

The secret to setting up a Brick or Paver Walkway is to very first appropriately prepare the location where the bricks/pavers are to be set up. The location ought to be removed a minimum of a foot down, eliminating all topsoil and clay soil. In addition, string lines ought to be strung on each side of the walkway. The string lines show the finished height of the sidewalk.
Once the location has been dug down, 3/4" gravel stone need to be laid in and tamped down tightly. 2" of sand, or stone dust should be spread over the gravel. Again the sand/stone dust need to be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline ought to equate to the thickness of the brick or paver.

Now that you have a steady base, place a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your sidewalk border and assistance to preserve the here integrity and shape of the sidewalk.

As soon as this is done, you can then start to lay the bricks/pavers. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again help maintain the stability of the pathway.

When constructing the sidewalk, undoubtedly bricks/pavers will need to be cut or divided. Unless you wish to buy or lease an expensive wetsaw, I would recommend buying a basic brick/paver splitter. It is basically a sculpt with a large end that is the width of the bricks/pavers. To actually cut/split the brick/paver, lay it in a bed of sand and location the chisel at a 75 degree angle over the area where you wish to break the brick. Using a hammer strike the butt end of the sculpt strongly. You might require to do this a couple of times. You might also wish to flip here the brick/paver over and strike the other side of the brick utilizing the hammer and chisle. Within one or two strikes the brick/paver need to break cleanly. If your sidewalk has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the more info outdoors edges with additional sand, and then shovel in the topsoil and load down strongly.
Spread stone dust over the brand-new sidewalk and sweep into the fractures. This will complete the interlocking of the bricks and help to get rid of any weed growth.


In addition, installing a Brick or Paver pathway does not always require a pro. The key to setting up a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipeline or journal board the length of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and help to keep the stability and shape of the walkway. Inevitably bricks/pavers will require to be cut or split when constructing the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *